Water Heater Replacement – Why You Should Consider Replacing Your Water Heater

Access to hot water is one of the necessities of modern life. When your water heater begins to break down, you need a professional plumber like Water Heater Replacement Denver to help you install a new one.

Water Heater Replacement

A leaking tank or a corroding dip tube are obvious signs that it’s time to replace your water heater. But other signs may not be as apparent.

If you have a water heater that’s close to the end of its lifespan, it may be more cost-effective to replace it rather than repair it. It’s important to remember that replacing a water heater isn’t just about the initial purchase price; factors like size, energy efficiency and brand quality will affect your long-term expenses. In addition to shopping around for the best quotes, you can take advantage of rebates and tax credits to reduce your upfront costs.

The most significant expense associated with water heater replacement is the cost of labor. This will vary depending on whether you are replacing a tank-style water heater with another tank-style water heater or an upgrade to a tankless water heater. A professional installation will ensure that your new water heater is properly connected to your home’s plumbing and gas lines, complies with local regulations and safety standards, and is safe to operate.

You’ll also need to consider any additional costs that might arise during the course of the project. These can include things like a permit, inspection, and removal and disposal of the old unit. Permit fees typically range from $50 to several hundred dollars, and inspections may be required by your local building department.

Other potential extras that can add to the cost of water heater replacement include a dip tube, which is used to transfer cool water from the top of the water heater back down to the element for reheating. If the dip tube wears out, it will cause cool water to mix with your hot water, which can result in lower overall water temperature. Replacing the dip tube is a relatively straightforward task and shouldn’t cost more than $150.

A thermostat is another common component that can go bad and require replacement. The thermostat is a small part that determines how much gas the element uses to heat your water. If the thermostat is faulty, it can lead to higher energy bills or early water heater replacement. Replacing the thermostat can cost an average of $200.

If your water heater is older, you’ll likely need to replace the dip tube and thermostat. Adding these replacements can increase your initial investment, but it will help to extend the lifespan of your water heater.

Energy Efficiency

Water heating is typically the second largest energy expense in a home. Proper maintenance and the use of high-efficiency equipment can cut costs and help reduce carbon emissions. The most effective way to do this is with a heat pump water heater (HPWH), which produces heat using the same technology that refrigerators use to stay cold. HPWHs emit no direct emissions and can deliver as much as half to three times the energy savings of traditional electric resistance or gas water heaters.

When choosing a new water heater, consider the gallon capacity and recovery rate that best fits your household needs. You’ll also want to make sure the new model has an ENERGY STAR rating and has a high Uniform Energy Factor (UEF) to maximize energy efficiency.

Energy efficient models are a great choice for those who don’t want to pay more upfront, but still want the benefits of reducing energy bills. When selecting a tankless model, look for one with an Energy Factor Rating that’s at least 0.95. This will help the unit operate more efficiently by minimizing thermal losses from the hot water pipes.

If your household has consistently had problems with running out of hot water, it’s a good time to consider replacing it with a more efficient model. This could also be a sign that the heater is overloaded or that it’s nearing the end of its life.

Water heaters are usually designed to last up to 12 years for traditional units with tanks and up to 20 years for tankless models. If your unit is nearing the end of its life, it’s a good idea to perform a cost-benefit analysis to determine whether it would be more cost effective to repair it or replace it entirely.

If you’re looking for a more environmentally friendly alternative to traditional water heaters, consider installing a solar model. These are becoming more and more popular, thanks to their ability to cut both utility costs and carbon emissions. Many manufacturers offer incentives for customers to install these products, including federal tax credits and rebates. Check with your local water heater installer to find out what options are available in your area.


The installation process varies by water heater type and location in the home, so you should consult the manufacturer’s instructions to ensure the best results. A qualified Carter professional plumber can safely connect your new water heater to your home’s existing plumbing and gas lines in compliance with local codes and regulations. If the existing water or gas line needs to be replaced or extended, this will add to the cost of the installation.

The first step in the replacement process is to drain and disconnect the old unit. It is recommended that you have a second person to help you move the heavy unit up and down stairs or from one location to another. Once the unit is disconnected, you can dispose of it according to your local waste management requirements.

Next, the new unit must be connected to the incoming water pipe and the power wires (if electric). Make sure that all connections are secure and tight, then fill the tank with water and turn it on. Be aware that it may take several hours for the unit to heat up and produce hot water.

If your new unit is a gas water heater, it must be vented properly to avoid carbon monoxide poisoning. Follow the manufacturer’s instructions for proper venting, which is typically through a rim joist in the home’s exterior wall. If your home doesn’t have a rim joist, install a new stainless steel vent pipe with an approved connector or kit.

If you’re switching from a tank to a tankless design, the installation process will take longer because you’ll need to connect it to your existing home’s plumbing and a gas line. This process is complicated and requires the services of a skilled plumbing professional.


A water heater is often out of sight and out of mind until it starts to break down. When it stops working, your quality of life is affected in many ways. Suddenly, you may find that you can’t take hot showers or use your washing machine or dishwasher. If you have a young family, this is especially distressing. You can probably get your water heater repaired, but it’s a good idea to consider replacing it sooner rather than later.

The average lifespan of a water heater is around 10 years. It is possible to extend this by draining the tank annually and using an anode rod. You can learn more about this process by visiting our info center, but be aware that it’s not a permanent solution. Water heaters are prone to rust and corrosion.

Rust in your home’s water is a sign that the water heater is nearing the end of its useful life. It could also indicate that the tank has a leak, which can cause serious problems, such as flooding and damage to your belongings. If you see rust in your home’s water, turn off your water heater and call a professional immediately.

Another indication that your water heater is nearing the end of its lifespan is high energy bills. Water heaters with sediment buildup have to work harder to heat your water, so they consume more electricity. The extra strain on the unit can also accelerate the amount of damage that it suffers.

Other signs that your water heater is on its last legs include strange noises and smells. These could be caused by a chemical reaction between the anode rod and sulfur in your water. If you notice a musty smell or discolored water, shut off your water and drain the tank. This should get rid of the problem, but if it persists, it’s time to replace your water heater.

If your water heater is making loud rumbling or popping sounds, it may have a broken dip tube. This is a small part that can break down over time, but it’s relatively cheap to repair. It allows cold water to enter the upper section of your tank, reducing your water temperature. A professional plumber will be able to fix this for you, although you’ll need to install a new dip tube.